It's designed for conveying light and medium loads for order preparation, distribution an dfor assembly lines. The circuit board is separated from the gear motor in order to optimize the performance, durability of the roller and to offer diverse functions such as pulse signals, acceleration/deceleration, optional position holder. The assembly can be controlled by PLC.
ELEKTROMECANICAL
Direct current and brushless
24V DC (+/- 10 %) - ripple ratio < 10 %
Insulation index
E
Operation at 40°C
Continuous: 100%
Intermittent:
1800 starts / hour maxi
Minimum duty cycle = 1 s ON/ 1 s OFF
ED = ON / (ON + OFF) ≤ 50 %
Brakes
Dynamic braking
Protection index
IP54 (IP65 or cold room, on request)
Cable length
300 mm with JST connector - 9 pins
Protection
Thermal protection (>95°C for circuit board, >110°C for motor)
Protection against induced voltage
Environment
0°C/+40°C - no condensation - or corrosive or explosive atmosphere
Vibrations < 0,5G
Sound level
≈ 52 dB nominal 1 meter away
Speed code
15 25 55 90
Reduction ratio
1/44,90 1/26,67 1/12,64 1/7,5
Connector
9-pin JST #S9B-XH-A
CONTROL
Circuit board functions
see characteristics of CBM-105 and HB 510
